Dynaudio · BM · Studio monitor

BM5 mkIII

Product description
The third generation of the BM5, and the point where the classic BM range picked up a DSP. The crossover at 1.9 kHz is digital, which is what lets this one carry position and filter switches the older analogue BMs do not have, and the top end reaches 24 kHz against their 21. Smaller and lighter than the BM6A beside it — 7.7 kg, 32 cm tall — with 50 watts a side rather than 100, RCA as well as XLR, and standby draw down at 0.3 W. Rear-ported, 42 Hz. Note on the image: the hero here is this speaker's own front render rather than the press photograph supplied, which is labelled as the BM5 Compact mkIII, a different and smaller model.

Performance — where it sits in the catalog

BassTrebleCone area
Bass reachTreble reachCone area
BM542 Hz24 kHz220 cm²
Median39 Hz24 kHz332 cm²
How to read this chart

Each axis spans the range the 114 studio monitors in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of this speaker's own class, the 96 active studio monitors — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Sensitivity, Easy load — the maker publishes no figure. Active speakers quote no sensitivity and no impedance, because with the amplifier inside both describe the electronics rather than the cabinet.

Units
TypeStudio monitor
HiFi ladder position#30 of 114 studio monitor
PowerActive
Height320 mm
Width186 mm
Depth296 mm
Footprint551 cm²
Space taken17.6 L
Weight7.7 kg
EnclosureBass reflex, rear port
Drivers1× 28 mm tweeter (soft dome), 1× 165 mm mid-bass (MSP cone)
Crossover frequency1900 Hz
Frequency response42–24000 Hz (±3 dB)
Amplification (per driver)tweeter 50 W · mid-bass 50 W
Total amp power100 W
Max SPL @ 1 m118 dB
Hi-res audio—
Wired inputsXLR balanced, RCA
Streaming / wireless—
Outputs—
Room correctionManufacturer presets
Primary + secondary pair—
Wireless inter-speaker link—
Latency—
Idle power0.3 W
Max consumption94 W
Where to buyCheck availability ↗
Manufacturerdynaudio.com ↗
Product pageOpen product page ↗

Suggested TrueScale comparisons

Tap any speaker to see it beside this one at true, real-world scale.