Dynaudio · BM · Studio monitor

BM6A

Product description
The BM range's middle monitor and, for a long stretch, one of the default nearfields in project studios: a 6.5-inch MSP cone and a 28 mm soft dome, 100 watts of discrete MOSFET amplification each, crossed at 2.2 kHz by an analogue network rather than DSP. Rear-ported, 41 Hz, 11 kg, XLR only — there is no digital input, no room correction and nothing to configure, which is either the appeal or the limitation depending on the room. 118 dB maximum for a pair at a metre. Dynaudio no longer publishes a price and US dealers have stopped stocking it.

Performance — where it sits in the catalog

BassTrebleCone area
Bass reachTreble reachCone area
BM6A41 Hz21 kHz220 cm²
Median39 Hz24 kHz332 cm²
How to read this chart

Each axis spans the range the 114 studio monitors in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of this speaker's own class, the 96 active studio monitors — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Sensitivity, Easy load — the maker publishes no figure. Active speakers quote no sensitivity and no impedance, because with the amplifier inside both describe the electronics rather than the cabinet.

Units
TypeStudio monitor
HiFi ladder position#36 of 114 studio monitor
PowerActive
Height338 mm
Width217 mm
Depth321 mm
Footprint697 cm²
Space taken23.5 L
Weight11 kg
EnclosureBass reflex, rear port
Drivers1× 28 mm tweeter (soft dome), 1× 165 mm mid-bass (MSP cone)
Crossover frequency2200 Hz
Frequency response41–21000 Hz (±3 dB)
Amplification (per driver)tweeter 100 W · mid-bass 100 W
Total amp power200 W
Max SPL @ 1 m118 dB
Hi-res audio—
Wired inputsXLR balanced
Streaming / wireless—
Outputs—
Room correction—
Primary + secondary pair—
Wireless inter-speaker link—
Latency—
Idle power—
Max consumption200 W
Where to buyCheck availability ↗
Manufacturerdynaudio.com ↗
Product pageOpen product page ↗

Suggested TrueScale comparisons

Tap any speaker to see it beside this one at true, real-world scale.