Dynaudio · LYD · Studio monitor

LYD 5

Product description
The smallest LYD, and the one where the crossover point tells the story: 5.2 kHz, far higher than the rest of the range, because a 5-inch cone is being asked to carry almost everything. 26 cm tall, 5.7 kg, 60 Hz at the bottom. Like every LYD it has DSP doing three jobs — Bass Extension shifts the low corner by 10 Hz either way, Position retunes for free-standing or within 50 cm of a wall, and Sound Balance tilts the overall response — which is what makes a monitor this small usable in the kind of room it tends to end up in. Class D, 50 watts a side, XLR and RCA. $499 each.

Performance — where it sits in the catalog

BassTrebleCone area
Bass reachTreble reachCone area
LYD 560 Hz21 kHz133 cm²
Median39 Hz24 kHz332 cm²
How to read this chart

Each axis spans the range the 114 studio monitors in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of this speaker's own class, the 96 active studio monitors — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Sensitivity, Easy load — the maker publishes no figure. Active speakers quote no sensitivity and no impedance, because with the amplifier inside both describe the electronics rather than the cabinet.

Units
TypeStudio monitor
HiFi ladder position#13 of 114 studio monitor
PowerActive
Height260 mm
Width170 mm
Depth211 mm
Footprint359 cm²
Space taken9.3 L
Weight5.7 kg
EnclosureBass reflex, rear port
Drivers1× 28 mm tweeter (soft dome), 1× 127 mm mid-bass (MSP cone)
Crossover frequency5200 Hz
Frequency response60–21000 Hz (±3 dB)
MAP (USD)$499 each
Amplification (per driver)tweeter 50 W · mid-bass 50 W
Total amp power100 W
Max SPL @ 1 m106 dB
Hi-res audio—
Wired inputsXLR balanced, RCA
Streaming / wireless—
Outputs—
Room correctionManufacturer presets
Primary + secondary pair—
Wireless inter-speaker link—
Latency—
Idle power0.5 W
Max consumption100 W
Where to buyCheck availability ↗
Manufacturerdynaudio.com ↗
Product pageOpen product page ↗

Suggested TrueScale comparisons

Tap any speaker to see it beside this one at true, real-world scale.