Dynaudio · LYD · Studio monitor

LYD 7

Product description
The middle LYD and the one most studios end up with: a 7-inch MSP cone under the same 28 mm soft dome, crossed at 4.3 kHz, in a cabinet that happens to be exactly the size of the BM5 mkIII. Same DSP as the rest of the range — Bass Extension, Position and Sound Balance — and the same 50 watts a side of class D, but 55 Hz instead of the LYD 5's 60 and 3 dB more output. What reviewers keep returning to is behaviour at low volume: the response holds together quietly, which matters more in a small room than the last few decibels of headroom. $649 each.

Performance — where it sits in the catalog

BassTrebleCone area
Bass reachTreble reachCone area
LYD 755 Hz21 kHz255 cm²
Median39 Hz24 kHz332 cm²
How to read this chart

Each axis spans the range the 114 studio monitors in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of this speaker's own class, the 96 active studio monitors — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Sensitivity, Easy load — the maker publishes no figure. Active speakers quote no sensitivity and no impedance, because with the amplifier inside both describe the electronics rather than the cabinet.

Units
TypeStudio monitor
HiFi ladder position#31 of 114 studio monitor
PowerActive
Height320 mm
Width186 mm
Depth296 mm
Footprint551 cm²
Space taken17.6 L
Weight8 kg
EnclosureBass reflex, rear port
Drivers1× 28 mm tweeter (soft dome), 1× 178 mm mid-bass (MSP cone)
Crossover frequency4300 Hz
Frequency response55–21000 Hz (±3 dB)
MAP (USD)$649 each
Amplification (per driver)tweeter 50 W · mid-bass 50 W
Total amp power100 W
Max SPL @ 1 m109 dB
Hi-res audio—
Wired inputsXLR balanced, RCA
Streaming / wireless—
Outputs—
Room correctionManufacturer presets
Primary + secondary pair—
Wireless inter-speaker link—
Latency—
Idle power0.5 W
Max consumption100 W
Where to buyCheck availability ↗
Manufacturerdynaudio.com ↗
Product pageOpen product page ↗

Suggested TrueScale comparisons

Tap any speaker to see it beside this one at true, real-world scale.