Kanto · YU · Bookshelf

YU4 G2

Product description
The YU is the line with a turntable in mind: a switchable phono stage built in, so a deck plugs straight into the speaker with no box in between. The G2 pairs 110 W RMS with a 100 mm abaca-reinforced paper cone — abaca is a banana-plant fibre, used here to stiffen the pulp.

Performance — where it sits in the catalog

BassTrebleCone area
Bass reachTreble reachCone area
YU460 Hz22 kHz83 cm²
Median45 Hz23 kHz154 cm²
How to read this chart

Each axis spans the range the 485 bookshelves in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of this speaker's own class, the 98 active bookshelves — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Sensitivity, Easy load — the maker publishes no figure. Active speakers quote no sensitivity and no impedance, because with the amplifier inside both describe the electronics rather than the cabinet.

Units
TypeBookshelf
HiFi ladder position#21 of 485 bookshelf
PowerActive
Height233 mm
Width140 mm
Depth205 mm
Footprint287 cm²
Space taken6.7 L
Weight3.7 kg
EnclosureBass reflex, rear port
Drivers1× 100 mm mid-bass (abaca-reinforced paper cone), 1× 25 mm tweeter (silk dome)
Frequency response60–22000 Hz
MAP (USD)$449.99 / pair
Amplification (per driver)—
Total amp power110 W
Max SPL @ 1 m—
Hi-res audio24 bit / 96 kHz
Wired inputsRCA, RCA Phono, Optical (Toslink), USB Audio
Streaming / wirelessBluetooth
OutputsRCA sub-out
Room correction—
Primary + secondary pairYes
Wireless inter-speaker link—
Latency—
Idle power—
Max consumption—
Where to buyCheck availability ↗
Manufacturerkantoaudio.com ↗
Product pageOpen product page ↗

Suggested TrueScale comparisons

Tap any speaker to see it beside this one at true, real-world scale.