TrueScaleAudio

Compare speakers at true scale

Pick two speakers and see them side by side at their real-world size.

Speaker A

Stands apply to bookshelves only

Speaker B

Stands apply to bookshelves only

References

Front view — side by side at true scale

AKlipsch JubileeBMonitor Audio Platinum 300
Klipsch Jubilee front view
Monitor Audio Platinum 300 front view

Click either cabinet to swap A ↔ B · Reference height: 1765 mm (176.5 cm) · 1 mm = 0.32 px

Plan view — footprint at true scale

front wall
A9799 cm²1286 mm762 mm
B2256 cm²429.8 mm525 mm
0 mm100 mm30 mm

A shelf applies to bookshelf speakers only — one of these stands on the floor.

Seen from above, both pushed back to the same front wall — the wall behind the speakers. Only height, width and depth are published, so each cabinet is drawn as a rectangle: this is the surface a speaker reserves, not its exact outline. A curved or tapered cabinet takes a little less. How far a speaker should sit from the wall is yours to set: makers rarely publish it, and the ones that do disagree by design.

Performance — where each one sits in the catalog

BassTrebleSensitivityEasy load
Bass reachTreble reachSensitivityEasy load
Jubilee18 Hz20 kHz107 dB8 Ω
Platinum 30017 Hz60 kHz88 dB4 Ω
Median32 Hz30 kHz90 dB6 Ω
How to read this chart

Each axis spans the range the 648 floorstanders in the catalog actually cover, so equal distance means equal difference — and for cone area and the two frequencies, which are read as ratios, equal distance means equal ratio. The dashed inner ring is where the scale starts, not zero. Ranked within a class because a bookshelf measured against floorstanders is feeble on every axis for the single reason that it is a bookshelf. Cone area is summed from the drive units — no maker publishes it. Bass and treble reach are quoted to different tolerances and only 56% of the catalog says which, so read those two axes as approximate. The grey outline is the median of the pair's own class, the 600 passive floorstanders — same type, same side of the active/passive line, which matters because the two halves are not the same product: the median active bookshelf carries 155 cm² of cone against the passive median's 219. Median rather than mean, because a handful of very large cabinets would drag a mean above most of the class it claims to describe. Not shown: Cone area — published by only one of the two. An outline reaching one more vertex than its neighbour reads as the bigger speaker when the only difference is which maker filled in a spec sheet. The figure is still in the table below.

Klipsch JubileevsMonitor Audio Platinum 300

The Klipsch Jubilee stands 176.5 cm tall — about 63.4 cm more than the Monitor Audio Platinum 300 at 113.1 cm. On footprint the Klipsch Jubilee is the wider cabinet (128.6 cm versus 43.0 cm). At 107 dB against 88 dB, the Klipsch Jubilee is the easier load to drive and plays louder from the same amplifier. Low frequencies come from a 305 mm cone on the Klipsch Jubilee and a 203 mm cone on the Monitor Audio Platinum 300. On price, the Klipsch Jubilee sits higher — about $35,000 a pair against $19,999 for the Monitor Audio Platinum 300.

Specifications

AB
ManufacturerKlipschMonitor Audio
ModelJubileePlatinum 300 3G
HiFi ladder position#626 of 648 floorstander#363 of 648 floorstander
Height1765 mm1131.1 mm
Width1286 mm429.8 mm
Depth762 mm525 mm
Footprint9799 cm²2256 cm²
Space taken1729.6 L255.2 L
Weight185 kg53.6 kg
Enclosurebass-reflex-frontbass-reflex-rear
Drivers1× 25 mm tweeter (K-693 titanium compression diaphragm), 2× 305 mm woofer (K-283 fiber-composite cone)1× tweeter (MPD III (Air Motion Transformer)), 1× 100 mm midrange (RDT III C-CAM), 2× 203 mm woofer (RDT III C-CAM)
Crossover frequency340 Hz650 / 3000 Hz
Frequency — low18 Hz17 Hz
Frequency — high20000 Hz60000 Hz
Sensitivity107 dB88 dB
Impedance8 Ω4 Ω
Recommended amp—200–800 W
MAP (USD)$35,000 / pair$19,999 / pair
Where to buyCheck availability ↗Check availability ↗
Brand websiteklipsch.com ↗monitoraudio.com ↗
Product pageOpen product page ↗Open product page ↗

Larger value highlighted in green. For low-frequency extension, lower Hz = greater bass reach, so the deeper side is highlighted.